Hi there i'm new to the forum and was hoping to have some help identifying a wood lathe i have. this lathe has been in my family for years in fact could go back as far as my great grandfather all i know is it's been around for ever.. Sawmill creek woodworkers forums. if this is your first visit, be sure to check out the faq by clicking the link above. you may have to register before you can post: click the register link above to proceed. to start viewing messages, select the forum that you want to visit from the selection below.. Become a better woodworker with these projects, tips and ideas for building furniture, cabinets and other woodworking projects..
Welcome to woodnet's woodworking forums. here you'll find forums for general woodworking, power tools, hand tools, home improvement, and for selling your tools (a free classified ad forum). everyone is welcome to read and post in these forums.. Bevel the ends of the other board, cut dadoes, which are grooves cut into the wood with a router or a table saw with a dado blade, cross- wise (cut a dado on scrap and test-fit the shelves first!) and cut it into four narrower boards, two at 1-3/8 in. wide and two at 4 in..
